Posted on

Industrial Arduino Norvi Getting started guide

Industrial Arduino NORVi

Getting started with Industrial Arduino

It really does not need to be documented on getting started with NORVI. Still we have made a guide to clear your doubts.
NORVI products represents a development board with industrial level protection
and attenuation enclosed in an industrial enclosure.
The device comes marked with all necessary information to start your projects.

Let’s start with
Power supply.

NORVI Industrial Arduino is rated: 24V DC 1A
24V DC 1A Power supply is recommended.
All the NORVI Industrial Arduino can be powered up with the USB Connection, It is required to use an external power supply to get the full functionality
.
`

Programming the controller.

All the devices are standard with a USB Port for programming.
NORVI Models will be recognized as following within the IDE
Table1.0 

NORVI CEMA

Arduino
micro

NORVI IIOT

COM port

NORVI ARITA MEGA2560

ARDUINO
MEGA2560

NORVI ARITA STM32F103VCT6

ARDUINO Maple

 

 

 

 

Supported IDE

NORVI ARITA
NORVI CEMA

 

NORVI IIOT
   

Selecting the board
Select the appropriate Arduino board according to NORVI
model. Refer
Table1.0

Addressing Inputs & Outputs
It is done the same way you address, a development boards pin with your programming IDE.
Below are few examples for better understanding

NORVI IIOT : Relay ON/OFF

 



 

 



 

 

Let’s say we need to turn on R0 Relay.


Referring to Quick Start Guide or terminal marks
R0 is connected to IO 14 , Arduino code example is as
follows

 

void setup() {

// Declare IO14 as OUTPUT

pinMode(14, OUTPUT);

}

void loop() {

// put your main code here, to run
repeatedly:

digitalWrite(14, HIGH); // Turn ON 14(R0)

delay(1000);

digitalWrite(14, LOW); // Turn
OFF 14(R0)

delay(1000);

}

NORVI IIOT : Digital Input

 

Reading status of I0 and printing it on Serial.
Referring to Quick Start Guide or terminal marks
I0 is connected to IO 18, Arduino code example is as
follows

void setup() {

// Declare IO14 as OUTPUT

Serial.begin(9600);

pinMode(18, INPUT);

}

void loop() {

// put your main code here, to run
repeatedly:

Serial.println(digitalRead(18));

delay(1000);

}

You can download quick start
guides and reference manuals via following link
https://norvi.lk/support/

Order Online
https://norvi.lk/products/